For Those Stubborn Windows

Do you have a window that keeps on sliding down? Well,  we have a few tips here to fix that. You’ll need a ruler/dowel, a pair of window controls (less than $5 from your local hardware store), box nails (about $1 each also from the hardware store), a hammer, measuring tape, and pencil.

To get started, you’ll have to push the window as high as you will want it to open. To do this, you’ll need to use your ruler or dowel to hold it in that position. Place the window control in the channel on one side, then align the top edge of the control with the bottom of the sash. Afterwards, nail it into place. That wavy part of the control holds the window up and when it’s pushed in, it’ll allow the window to slide over it and close.

Then, measure the distance between the nails and the sill and mark the same distance for the other channel. Nail the second control into place. Afterwards, remove the ruler or dowel and lower the window.

It might be a little tricky, but just go through the process slowly and you’ll get it. Good luck!

Tags: , ,

Leave a Reply

You must be logged in to post a comment.